Coval Metal Coat

Coval Metal Coat is a highly durable, industrial grade, heat resistant coating for the protection of all metal surfaces, painted or unpainted. It reduces wear, stains and corrosion, including: rust, salt spray, acid rain, UV damage, oxidation, and galvanic corrosion The nano/covalent technology, creates a molecular bond with surfaces usually only requiring one coat. Coval Metal Coat can be sprayed, rolled, brushed, or applied by dipping, and is fast drying. In most cases, only one coat is required.

Note:Unpainted iron or steel will requires 2 coats, wet on tack, 10-15 minutes apart.

Test: As with all Coval products, it is recommended to test for compatibility in a small area before full application.
Available in Clear Gloss or Satin, and a choice of 20 colored stains.


Surfaces must be clean, dry and in sound condition. Remove all oil, dust, grease, dirt, loose rust and other foreign material; including all existing silicon sealers. Use Coval step#1 Cleaner for Unpainted surfaces or Coval step #1 Cleaner for Painted surfaces if the metal is painted. Hot rolled steel must have the slag removed by sandblasting or grinding off. Stir thoroughly before and during application to fully suspend nanoparticles. Mask off all areas not to be painted. This product may be applied in a variety of ways: HVLP sprayer with a 1.0-1.3 tip and set to approximately 25 PSI (recommended), or otherwise, by brush, roller or dipping. Clean-up immediately with acetone.

Note: All equipment must be chemical and acetone resistant.

Caution: A professional spray mask should be used with this product, as well as eye protection, rubber gloves, and coveralls.

Coval Metal Coat - Specifications

Uses Seals and protects from UV, corrosion, rust, salt and acid stains. Prolongs life of previously coated surfaces.Surface protection As with all Coval products, eases removal of graffiti. 
Suitable surfaces Iron, steel, stainless steel, aluminum, galvanized steel, copper and bronze, powder coated metals, and painted and primed metals.Solvent based
Solvent based YES  
Water based NO  
Flammable YES  
Voc"s Under 100 VOCs
Coverage 640 to 800 sq ft/gal. One coat. Unpainted iron or steel will requires two coats – wet on tack 10-15 minutes apart.
Clean-up While soft: Acetone When hard: none
Dry time All Coval Molecular Coatings are dry to the touch in 2-3 hours. Full cure 7 days.Note: It is important to protect surface from water or rain for at least 5 hours after application.
Application Method May be sprayed, brushed rolled or applied by dipping. Equipment must be chemical and acetone resistant
Other relevant Coval products Coval step#1 Cleaner for Unpainted Surfaces Coval step #1 Cleaner for Painted Surfaces
Sheen Gloss or satin
Porosity Non-breathable
Flash point
Ambient temp and humidity limits 45° F to 105° F working limit. Safe Relative Humidity: 90% or less

WARNING: Always use appropriate protection when using Coval products; including appropriate respirator,safety goggles, butyl-rubber gloves and coveralls; also, mask off or cover, all adjacent areas.

Subscribe now to receive industry information, relevant news and special updates.

We respect your privacy.